ATM Configuration and Troubleshooting Guide

Configuring LAN Emulation Interfaces
Verifying the ELAN Interface Configuration
Chapter 4 57
Verifying the ELAN Interface Configuration
To verify that the LEC has successfully joined its primary ELAN and, if
configured, its secondary LAN Emulation services, follow these steps:
Step 1. To view the LEC configuration and status information, exit SAM. At the
command line, type this command:
elstat -n net_interface -v
Examples:
(HP-UX 10.20) For interface ela1: elstat -n ela1 -v
(HP-UX 11.X) For interface el100: elstat -n el100 -v
The output could look like this (note, this example is for a configuration
that includes LANE V2 and MPOA but does not include secondary LAN
Emulation services):
Primary LEC configuration and status information
ATM Address :
4700918100000000e014cbb701.0060b059012f.12
LLC multiplexed
ATM address :
4700918100000000e014cbb701.0060b059012f.12
MAC address : 0060b059012f
Local Segment ID : 000
ELAN name : buro1_2
Status : Operational
State : Current
LECS’s ATM Address :
47000580ffe1000000f21a1e28.0020481a1e28.05
(Manual entry)
Configuration Direct VCC : -,-
LES’s ATM Address :
47000580ffe1000000f21a1e28.0020481a1e28.10
Control Direct VCC : 0,110
Control Distribute VCC : 0,255
BUS’s ATM Address :
47000580ffe1000000f21a1e28.0020481a1e28.11