ATM Configuration and Troubleshooting Guide

Configuring SVCs and PVCs
Configuring SVC Traffic Parameters
Chapter 5 73
Using the Command atmconfig
See the atmconfig(1M) man pages for more information about how to
configure an SVC traffic profile using the atmconfig add command.
NOTE Different types of traffic profiles are available on different HP ATM
adapters. Ensure that you configure a supported SVC traffic profile when
you use the command atmconfig add.
Modifying an SVC Traffic Profile
You can configure an SVC traffic profile in SAM or by using the command
atmconfig delete followed by the command atmconfig add.
Using SAM
NOTE The ABR traffic type is supported on SVCs only if (1) your ATM switch
supports UNI 4.0, and (2) you set the UNI version parameter to UNI 4.0
on the ATM adapter (see “Configuring the ATM Card Parameters” on
page 20).
To modify an SVC traffic profile in SAM, follow these steps:
Step 1. Log in as root.
Step 2. Type sam to start SAM.
Step 3. Select “Networking and Communications”.
Step 4. Select “Network Interface Cards”.
Step 5. Highlight the ATM adapter that you want to configure, and then choose
Configure from the “Actions” menu.
This opens the “Configure ATM Card” window, which lists all configured
interfaces for the ATM adapter.