ATM Release Notes

ATM Version I.11.11.30

Known Problems and Workarounds

Chapter 334

Known Problems and Workarounds

The known problems and corresponding workarounds for version K.11.11.10 of the ATM link

software on HP-UX 11i are as follows:

• For those wishing to use OLAR, your system may need to update its ﬁrmware. For

additional details, please refer to the Readme Before Installing or Updating to HP-UX 11i

document provided with your HP product.

• On HP VISUALIZE UNIX B1000, C3000, J5000, and J7000 Workstations, if you are

running a ﬁrmware version earlier than 3.2, the A5513A and A5515A HP-PCI ATM/155

adapters do not work if they are installed in the 66 MHz slots of those workstations (slot 2

of the B1000 and C3000, and slots 4 and 7 of the J5000 and J7000). The adapters do work

if they are installed in the 33 MHz slots of those workstations.

Workaround: Install B1000/C3000/J5000/J7000 ﬁrmware version 3.2 or later. The

ﬁrmware version 3.2 is available as ﬁrmware patch PF_CBCJ0032 (contact your

Hewlett-Packard representative for patch installation information). After the ﬁrmware is

installed, the adapters will work in any of the PCI slots in the B1000, C3000, J5000, and

J7000 workstations. Instructions for checking the ﬁrmware revision number are provided

in the workstation owner’s guide (interrupt the boot process and enter the command IN

-FV at the main menu of the boot console).

• If you are using a Nortel Centillion ATM switch that has a software version earlier than

4.0, you will most likely experience interoperability problems (see Nortel support

reference number CR 80877).

Workaround: Upgrade your Nortel Centillion switch to software version 4.0 or later.

• Installation error when installing EMS on a system where the Japanese version of EMS is

already installed.

The error messages that are generated are as follows:

ERROR: The EMS (B5736BA) and EMS Japanese (B5736BJ)

products cannot be selected together. Exit swinstall,

and run it again - this time only marking and installing

one or the other.

ERROR: The "checkinstall" script for "EMS-Config" failed (exit code

"1"). The script location was

"/var/tmp/AAAa02046/catalog/EMS-Config/pfiles/checkinstall".

* This script had errors and the execution of this product

cannot proceed until the problem is fixed. Check the above

output from the script for further details.