HP PCI Multiplexer Family Cabling, Diagnostics, and Troubleshooting Manual

Install Port Modules, Fan Out Cable & Power Supply
Install the PCI MUX Power Supply
Chapter 3 37
Remove the power plug cover protecting the power connector on the port
module (Figure 3-5).
Figure 3-5 Port module power plug cover and LEDs
WARNING Always connect the AC/DC adapter to a grounded wall outlet.
The power cord supplied with this product has a grounded plug.
Always use this power cord or a similar one according to your
national code
Warning: This AC/DC adapter has been designed to operate on all
power systems, including IT power systems. It is disconnected
from the power source by either disconnecting the power cord
from the AC/DC power inlet or by unplugging the cord from the
wall outlet. Use only the HP AC/DC adapter supplied with this
product.
Inset the DC output cable plug, with latch (Figure 3-5 insert) of the plug
facing the front of the module, into the port module connector. Press
down firmly until a snapping sound is heard.
Connect the cable for the power supply to an AC power outlet.