HP X.25/9000 User's Guide HP-UX 11i v3 (5900-1523, August 2011)

bill# x25server
dave# x25check [bill’s X.121 address]
If successful, you will receive the message “Remote connection succeeded.”
12. Test the files: x29hosts, x3config (at bill) using:
dave# padem [bill’s X.121 address]
If successful, you will receive the “login” message and you will be able to enter your details.
13. Test the files: x29hosts, x3config, Systems, Devices (at dave) using:
dave# cu -d9 bill
If successful, you will receive an output something like:
Autodialing - please wait
call dial(1761259328)
baud=19200, speed=19200, line=(null), telno=-
call find_dev(15076527500)
baud=19200, speed=19200, line=(null), telno=-
nomodem is 0
fixline(6, 19200)
fixline - direct
MDTR was not set
gdial(direct) called
call mode(1)
Connected
transmit started
receive started
Generic-Sys (generic) [HP Release A.B9.04]
login:
If you don’t see the “login:” prompt, type dave# uusnap. You should receive the following
output:
x29 --- --- --- LOCKED (pid 57602)
bill --- --- --- [error message]
Refer to the UUCP section in Chapter 9 of the Remote Access: User’s Guide (part number
B2355-90037) for more information on UUCP error messages.
14. Test the file permissions of both bill and dave using:
dave# /usr/lib/uucp/uucico -r1 -x9 -sbill
where -r1 indicates that dave is the “master” (for UUCP purposes) and -x9 is the highest
debugging level.
If successful, you should receive output similar to:
mchFind called (bill)
list (rmail) num = 1
list (/) num = 1
list (/) num = 1
list (ALL) num = 1
_Request (TRUE), _Switch (TRUE), _CallBack (FALSE), _MyName
(dave),
_Commands ALL
chdir(/var/spool/uucp/bill)
conn(bill)
ProtoStr = f
Device Type dev_bill wanted
mlock x29/bill succeeded
fixline(5, 19200)
fixline - direct
gdial(direct) called
/* X.25 connection established*/
getto ret 6
expect: (““)
UUCP support (x29uucpd) 107