HP X.25/9000 User's Guide HP-UX 11i v3 (5900-1523, August 2011)

TM = (4096 x 3) + (2 x 3 x 1024)) x 200
+ ((4096 x 3) + (2 x 5 x 128)) x 400
+ (2 x 5120)
TM = 9,123,840 (8.7 Mb)
Software requirements
Before installing the X.25 link product, make sure that the software listed below has been correctly
installed on your system. Refer to the related publication if you need more information about any
of these products. If you cannot find the software or information you need, contact your HP
representative.
• HP-UX operating system version 11i v3 – see Installation and Update for HP Integrity Servers
and HP 9000 servers.
• Internet Services – see HP-UX Internet Services Administrator’s Guide: HP-UX 11i v3.
Installing the X.25 link software
Follow the steps below to install the X.25 link software:
1. Insert the software media (tape or disk) in the appropriate drive.
2. Type: swinstall.
(See the man page on swinstall for more information on this command).
3. Click OK on the Specify Source window.
4. Highlight J2793B in the Software Selection dialog, then select Mark For Install from the Actions
menu to install all file sets in the bundle.
If you want to select only certain file sets, double-click on the product name to access the file
sets that you want to mark for installation (each time you double-click, you go down one level
in the bundle structure).
5. When you have marked the product components you want to install, select Install (analysis)
from the Actions menu.
6. When you have successfully completed the analysis, click OK from the Analysis dialog to load
the X.25 file sets.
The swinstall utility loads the file sets, runs the customized scripts for the file set, and builds
the kernel. Estimated time for processing: 8 to 10 minutes.
If the kernel build is not successful, the swinstall program returns you to a new shell. The
cause of the failure will appear at the end of the /var/adm/sw/swinstall.log file.
12 Installation