HP X.25/9000 User's Guide HP-UX 11i v3 (5900-1523, August 2011)

Figure 28 Flowchart 1
Flowchart 2 – Procedures and notes
Use these procedures to verify that your X.25 link is correctly initialized. Read the following notes
before carrying out the initialization check procedures in Flowchart 2.
Note 2-1 – x25stat
Level 2 is down if x25stat -d [device] -f returns a level 2 link state other than “normal.”
Note 2-2 – eisa_config
Sometimes x25init does not recognize the dual-port EISA interface (J2815A) after a first-time
installation. When you reboot your system after installing the dual-port EISA interface, you may
receive a message similar to:
Device /dev/x25_0p1 is not configured in the kernel
If this problem occurs, you can work around it by running the eisa_config utility in interactive mode
as shown below.
1. At the EISA prompt, type:
add !HWP19A0.CGF slot number
where slot number is the number of the EISA slot in which the interface card is installed.
2. Then type:
save
quit
3. Reboot your system.
Troubleshooting your X.25 link 131