HP X.25/9000 User's Guide HP-UX 11i v3 (5900-1523, August 2011)

prog_access _name Specifies the card's programmatic access name.
NOTE: For Series 712 workstations this is always
name=interface0.
+URC Specifies that outbound calls to this IP address will Use Reverse
Charging (URC).
-URC (Default) Specifies that outbound calls to this IP address will not Use
Reverse Charging (URC).)
+ARC Specifies that inbound calls to this IP address will Accept Reverse
Charging (ARC).
-ARC (Default) Specifies that inbound calls to this IP address will not Accept
Reverse Charging (ARC).
x25_card_device A device configured for one of your existing X.25 cards. This
information is used by the IP_to_X25 software to identify the interface
port through which the outbound packets will be sent.
CUG=n Specifies the Closed User Group index number used for placing calls
to this IP address. The index number is a two- or four-digit number.
Two digits corresponds to the basic format, and four digits corresponds
to the extended format of the CUG selection facility.
# You can put comments in your IP mapping table by including the #
character at the beginning of the line. Note that you cannot add
comments after a table entry.
NOTE: For non-DDN configured interfaces, all remote hosts must have entries in the IP-to-X.121
address map table. Remote hosts not on your X.25 network (that is, on the other side of gateways)
do not need to have map table entries. For more information, refer to the routing description in
this section.
140 Troubleshooting