HP X.25/9000 User's Guide HP-UX 11i v3 (5900-1523, August 2011)

Table 1 Field descriptions (continued)
DescriptionField
to 4). Note that p and x are only required for systems with dual-port or quad-port
cards.
Address assigned to each local X.25 interface (card or port) by the network carrier.
X.25 checks it for diagnostic and identification purposes only. This address is
X.25 Address
sometimes referred to as the X.121 address. Use the value given on your subscription
form.
Name given to the interface you are configuring (used for X.25 level 3 programmatic
access).
Programmatic Access
Name
Type of network to which the X.25 interface is attached (as it appears on your
subscription form). A complete list of possible networks is shown below. The default
is DTE_84.
Network Carrier Type
This field appears (with its default value) only if you select TRANSPAC as the Network
Carrier Type.
X.25 Packet Address
Network types
You must select a Network Carrier Type that matches the type of network to which you are
connected.
DTE_80DCE_88DCE_84DCE_80
DATANET1AUSPACDTE_88DTE_84
DCSDATEXP_DEUTSCHEDATEXP_AUSTRIADATAPAC
ITAPACHPPPNDDXPDDN
TRANSPACTELENETPSSLUXPAC
DATAPAKTELEPACIBERPACTYMNET
3. Click OK to return to the Configure X.25 Card window when you have finished configuring
the X.25 Address.
Configuring X.25 virtual circuits (VCs)
Follow the steps below to configure X.25 virtual circuits:
1. From the Configure X.25 Card window, select Configure Virtual Circuits. The following dialog
appears:
Configuring the X.25 link 15