HP X.25/9000 User's Guide HP-UX 11i v3 (5900-1523, August 2011)

of service to which you subscribe. Refer to your Network Subscription Form for the correct values
for your configuration.
Follow the steps below to verify level 3 values:
1. At the Configure X.25 Card window, select Verify Level 3 Values. The following dialog appears:
Figure 6 Verify level 3 values
2. Enter or modify field values as required (refer to the field descriptions below).
Table 6 Verify level 3 values field descriptions
DescriptionField
If fast select is enabled (Yes), up to 128 octets of information can be transferred in
call request and clear packets. The default is No (disabled). See your subscription
form.
Fast Select Accepted
The default is No (disabled). Use the value given on your subscription form.Flow Control Negotiation
If reverse charge is enabled (Yes), reverse charge calls can be accepted by the
application. If reverse charge is disabled (No), X.25 rejects reverse charge calls
automatically. The default is No. Use the value given on your subscription form.
Reverse Charge Accepted
Throughput class refers to line speed. If it is enabled (Yes), the Switched VC
Negotiated value is used; if disabled (No), no throughput class negotiation is
accepted. The default is No.
Throughput Class
Negotiation
3. Click Modify Flow Control Settings to modify Switched and Permanent VC flow control settings.
The following dialog appears:
Configuring the X.25 link 19