HP X.25/9000 User's Guide HP-UX 11i v3 (5900-1523, August 2011)

Table 14 Additional XOL specific configuration parameters (continued)
ValueFormatField
The destination MAC address to which
the XOL interface is connected.
One hexadecimal value. This value
must be prefixed with 0x.
XOL_destination_macaddr (replaces
the MAC address in the
lan_box_addr)
The destination SAP value of the peer
XOL interface. Set the value of DSAP to
One hexadecimal value. This value
must be prefixed with 0x.
XOL_DSAP
any even value in the range 0x70 -
0x7e, both inclusive.
The source SAP value of the local XOL
interface. Set the value of SSAP to any
One hexadecimal value. This value
must be prefixed with 0x.
XOL_SSAP
even value in the range 0x70 - 0x7e,
both inclusive. If the value for SSAP is
not provided, then SSAP takes the value
of DSAP.
Name of the standby LAN device used
for local failover. For more details about
Device name stringstandby_device**
this parameter, see “Configuring the
high availability feature for X.25 over
LLC2” (page 61). Required only for
local failover support.
The unique MAC address for the LAN
card in the LAN subnet. For more
One hexadecimal value; must be
prefixed with 0x
XOL_floating_macaddr**
details about this parameter, see
“Configuring the high availability
feature for X.25 over LLC2” (page 61).
Required only for local failover support.
**
Required for HA feature
NOTE: The configuration parameters may be specified in the old format. However, HP recommends
that you use the new format while specifying the configuration parameter. XOL is not supported
over APA (Auto Port Aggregation).
Following are two sample files. Example 1 (page 28) provides a sample file that has the old
parameters in the old format. Example 2 (page 28) provides a sample file that has the new
parameters in the new format.
Configuring X.25 over LLC2 27