HP X.25/9000 User's Guide HP-UX 11i v3 (5900-1523, August 2011)

def_outthruputclass 19200 # default thruput class
flowcontrol on # flow control negotiation allowed
neg_inpacketsize 128 # offered packet size if using flow control negotiation
neg_outpacketsize 128 # offered packetsize if using flow control negotiation
neg_inwindow 7 # offered window size if using flow control negotiation
neg_outwindow 7 # offered window size if using flow control negotiation
thruputclass on
neg_inthruputclass 19200 # offered thruput class if using thruput class
negotiation
neg_outthruputclass 19200 # offered thruput class if using thruput class
negotiation
pvc_inpacketsize 128 # packetsize for PVCs
pvc_outpacketsize 128 # packetsize for PVCs
pvc_inwindow 7 # window size for PVCs
pvc_outwindow 7 # window size for PVCs
# IP Related Parameters
IP 15.4.64.120 255.255.248.0 # IP address and subnet mask
mtu 1024 # max transmission unit 1024 octets
hold 300 # 5 minute hold timer
idle 600 # 10 minute idle timer
NOTE: For an XOL configuration, L3 packet sizes greater than 1024 are not supported.
If the XOL interface on the host is connected to a router supporting X.25 over LLC2, the router must
be configured with the correct routing entries. For example, if an XOL interface on the host is
connected to a CISCO router and the XOL configuration on the host is identical to the configuration
in the previous example, the following configuration is required:
To enable the cmns, complete the following steps:
1. Run the following command at the CISCO console:
Configure Terminal
2. Run the following command at the CISCO console:
Interface fastethernet 1/0
3. Run the following command at the CISCO console:
cmns enable
4. Run the following command at the CISCO console:
Ctrl+Z
To add routing entries to X.25 routing table, complete the following steps:
30 Configuration