HP X.25/9000 User's Guide HP-UX 11i v3 (5900-1523, August 2011)

1. Run the following command at the CISCO console:
Configure Terminal
2. Run the following command at the CISCO console:
x25 route ^ 7111 interface FastEthernet1/10 mac 0011.0a80.31d6
3. Run the following command at the CISCO console:
x25 route ^ 7222 interface FastEthernet1/10 mac 0800.09c4.728a
4. Run the following command at the CISCO console:
Ctrl+Z
Starting and stopping configuration
Starting
To initialize the x25overllc2 devices, execute the x25init command with the -L option at the command
prompt.
The syntax for execution is:
x25init -c <config_file> -L <llc2_config_file>
config_file is the generic X.25 product configuration file and llc2_config_file is the LLC2 specific
configuration file.
A sample invocation is as shown below:
x25init -c <x25init_def> -L<llc2_conf_def>
This command is executed once per box. It can be executed with different
<x25init_llc2_sampl> file but with the same <llc2_conf_def> file.
Stopping
To stop the communication with one box, the x25stop command is executed with the -L option.
The syntax for execution is:
x25stop -d <lan#>-L <XOL_logical_port_id>
<XOL_logical_port_id> is the XOL logical port identifier for the XOL interface on the given
LAN card.
NOTE: SMH support is not available for configuring X.25 over LAN(LLC2). Also, the x25init
command needs to be executed manually if the system is rebooted.
For a detailed description of the configuration, see x25overllc2((7)). For more information on how
to configure High Availability, see “Configuring the high availability feature” (page 58).
For more information on LLC2, see x25init((1M)), x25stop((1M)), and x25stat ((1M)) manpages.
NOTE: To configure a Highly Available XOL interface, See “X.25 High availability configuration”
(page 60).
Sample setup and configuration
The X.25 over llc2 supports one or more XOL interfaces. Following are the two example
configurations:
One Lan and two boxes configuration
A graphical representation of the above configuration with some arbitrary values for the MAC
addresses and lan-ids is shown below:
Configuring X.25 over LLC2 31