HP X.25/9000 User's Guide HP-UX 11i v3 (5900-1523, August 2011)

# START of customer defined halt commands.
/usr/sbin/x25stop -d /dev/x25_1l0
Sleep 2
# Assuming that lan2 was configured as standby lan
/usr/sbin/x25stop -d /dev/x25_2l0
Sleep 2
test_return 52
# END of customer defined halt commands
}
Verifying the X.25 link
After completing the installation and configuration instructions, follow these steps to verify your
link:
1. If you are using IP over X.25, use the ping command to check that the IP connection is
operating properly. Refer to your man pages for details on the ping command. Examples
are given below.
To check the connection to and from the network to the IP address (for example, 193.6.3.2),
type:
ping 193.6.3.2
To check the full connection across the network to the remote system’s IP address (for example,
193.6.1.1), type:
ping 193.6.1.1
2. If ping was unsuccessful, use the x25check and x25server commands to verify that the
X.25 connections are operating properly. Refer to your man pages for detailed information
on the these commands.
NOTE: If you have problems with the operation of your X.25 link, repeat the installation
process described in “Installation” (page 10) and the configuration instructions in this chapter,
or refer to “Troubleshooting” (page 130) for troubleshooting information.
70 Configuration