HP X.25/9000 User's Guide HP-UX 11i v3 (5900-1523, August 2011)

Table 17 Three possible critical resource analysis (CRA) outcomes (continued)
User ActionsButtons ActivatedScreen DisplaysNotesOutcome
Analysis complete”
messages.
change to the system.
Or,
Remove all cables
from the PCI I/O
card and click OK to
take you to the next
step.
Click Cancel to halt
the operation with no
change to the system
CancelDetailed message
describing the
affected critical
resource.
SMH will not allow
the operation to
proceed.
Critical resource(s )
identified.
Click Cancel to halt
the operation with no
OK and CancelDetailed message
describing these
resources.
SMH reports other
resources that are in
use with no
Other resources
identified.
change to the system.
Or,
Remove all cables
from the PCI I/O
detectable alternates.
For these resources,
you can cancel or
continue the
card and click OK to
operation based on
continue operations
your knowledge of
based on your
the current system
configuration.
knowledge of the
information being
reported.
NOTE: The cables must be removed from the PCI I/O card before proceeding with the OLR
operation.
8. Once you click OK on the Analyze Critical Resources screen, SMH begins to take the selected
card out of service. SMH requests a suspend operation for the driver of the selected card.
9. Once the drivers are suspended, SMH turns off the power to the slot in which the card is
located.
10. SMH then illuminates the amber attention LED on the slot itself to make the suspended card
more easily locatable on the system chassis.
11. SMH now requests that the card be replaced via a dialog box. Read the contents of this dialog
for any extra information (Expansion cabinets, warnings, etc.). Also at this point, SMH turns
off the slot’s green power LED.
12. Replace the target card. Please refer to your system manual for removal and insertion of the
PCI I/O cards.
NOTE: Do not connect the cables to the card at this point.
13. At this point, the amber LED should still be be activated, and the green power LED should still
be off.
Return to the console, and click OK on the Replace Card dialog.
WARNING! Pressing the Cancel button here will prevent you from easily restoring power
to this slot (or Power Domain). If this happens, you must shut-down, then re-boot, the system
to restore power.
14. Once you click OK, SMH first resets the attention LED to its normal state.
74 OLA/R overview and concepts