HP X.25/9000 User's Guide HP-UX 11i v3 (5900-1523, August 2011)

15. SMH completes the operation by reversing the sequence of actions. That is, SMH will:
• return power to the card slot, and enables power to the Green LED
• identify the new card
• resume driver operations to the card
16. Connect the cables to the card.
How to on-line add (OLA) a J3525A PCI card using SMH
NOTE: On-line addition will recognize and claim the interface card only if the X.25/9000
software is already loaded on the system. Also check if the appropriate J3525A drivers are loaded
in the kernel.
1. Read the information (below) in this step. An understanding of this section is important in order
for you to make the correct decision later in the procedure.
Enter the SMH I/O Cards area and look for a slot prior to inserting the card.
• You will see one or more entries marked “empty slot”, one of which you will choose to
house the new card.
• SMH will perform a Critical Resource Analysis prior to bringing the card on-line
2. Start SMH.
3. From the SMH Areas screen, select Peripheral Devices.
4. From the Peripheral Devices screen, select Cards.
5. From the I/O Cards screen, view the list of available I/O slots (will read “empty slot”). Select
the slot you wish to use.
6. From the Menu bar, select Actions.
7. From the Actions drop-down list, select Add.
8. SMH now performs a Critical Resource Analysis (CRA). That is, now that you have selected
to Add a card, SMH’s first step is to confirm that no critical resources will be disabled when
the power to the slot is switched off.
Output messages from the CRA process are presented in the Analyze Critical Resources screen
which will be shown before you can proceed. The messages displayed on this screen and the
availability to continue on from it (OK button activated) depend on the results of the analysis.
Table 18 Three possible critical resource analysis (CRA) outcomes
User ActionsButtons ActivatedScreen DisplaysNotesOutcome
Click Cancel to halt
the operation no
OK and Cancel“No affected
resources are critical
At this point, you can
still cancel the
replacement process.
No critical resources
identified.
change to the system.or in-use” and
Or, Click OK to take
you to the next step .
“Critical Resource
Analysis complete”
messages.
Click Cancel to halt
the operation with no
change to the system
CancelDetailed message
describing the
affected critical
resource.
SMH will not allow
the operation to
proceed.
Critical resource(s )
identified.
Click Cancel to halt
the operation with no
OK and CancelDetailed message
describing these
resources.
SMH reports other
resources that are in
use with no
Other resources
identified.
change to the system.
detectable alternates. Click OK to continue
For these resources, operations based on
you can cancel or your knowledge of
continue the the information being
reported.operation based on
How to on-line add (OLA) a J3525A PCI card using SMH 75