HP X.25/9000 User's Guide HP-UX 11i v3 (5900-1523, August 2011)

Unable to Connect to Remote NodeVC_CLEAR Packet was received with

CAUSE 0 : DTE Originated

DIAG 245 : Cannot Interpret Diagnostic Code

Example 20 Running x25check with an X.121 address

In the example below, the destination X.121 address of the destination node is specified as a

parameter to x25check. This example shows a successful test and assumes the

closed_user_group to be 51.

$ x25check 250207 -i interface0 -g 51

X25CHECK (c) COPYRIGHT Hewlett-Packard Company 1988.

Test Starts on .. Wed Dec 8 09:15:01 1993

Initialization of the test...

CALL packet sent ...

The following figures have been measured on the network:

Set up time : 267 ms

Remote Connection Succeeded

Example 21 Running x25check with a data packet

In this example, a DATA packet is sent following the CALL packet. The size of the DATA packet

(in octets) and the number of DATA packets to be sent are specified in addition to the X.121

address of the destination node. This example shows a successful test.

$ x25check 250207 -i interface0 -s 32767 -n 1

Test Starts on .. Wed Dec 8 09:15:47 1993

Initialization of the test...

CALL packet sent ...

DATA packet sent ...DATA packet received

The following figures have been measured on the network:

Set up time : 286 ms

Transit time : 24205 ms

Remote Connection Succeeded

x25stat

This command displays the status, configuration, and VC statistics of an X.25 interface. See the

man pages on x25stat for syntax and parameter information.

82 Diagnostic utilities