IEther-00 (iether) B.11.31.1307 Ethernet Driver Release Notes (1st Edition) HP-UX 11i v3

Table 3 HP-UX 11i v3 December 2012 fixes — IEther-00 B.11.31.1212

DescriptionSR number

On multiple-CPU systems and a high-transmit load, the iether driver might cause intermittent

system hangs or high CPU utilization.

QXCR1001247694

In addition, under these circumstances, systems with MC/Serviceguard might exhibit a

cluster-reformation or system Transfer Of Control (TOC).

Potentially poor network performance might be observed when operating the LAN adapter

at 10Mb or 100Mb half-duplex. The following adapters could be impacted: AD221A,

AD222A, AD393A, and rx2800 LAN on Motherboard (LOM) adapters.

QXCR1001200917

Table 4 HP-UX 11i v3 October 2012 fixes — IEther-00 B.11.31.1210

DescriptionSR number

After a LAN adapter port is reset, the statistics reported might reveal a large number of

Inbound Discards. Activity on the receive side might appear to be hung. The following LAN

adapter products could be impacted: AD221A, AD222A, AD393A, and rx2800 core

LAN-on-Motherboard (LOMs).

QXCR1001220405

The rx2800 LAN interface is on the system motherboard. This LAN adapter appears in ioscan output as “AH395-60001”.

Table 5 HP-UX 11i v3 September 2012 fixes — IEther-00 B.11.31.1209.01

DescriptionSR number

False link status reported when NC360m or NC364m autonegotiation is OFF (Intel

82571mezzanine adapters only). When autonegotiation is OFF for the NC360m or NC364m

QXCR1001202598

adapter, and the corresponding switch port is disabled, the LAN interface link status on the

system side is displayed by nwmgr and lanadmin as UP. It should be displayed as DOWN.

Link status detection delay with NC360m and NC364m PCIe Ethernet mezzanine server blade

adapter (Intel 82571mezzanine adapters only). When a link is down, there is a significant

QXCR1001216397

delay before the iether driver detects this and logs a nettl error. Reported delays range

from 2 to 36 seconds.

Table 6 HP-UX 11i v3 September 2012 fixes — IEther-00 B.11.31.1209

DescriptionSR number

System fails to produce a crash dump after a soft reset (TOC). This results because the iether

driver crashes when initializing at the same time that the system is performing the TOC (transfer

of control).

QXCR1001194114

4 Problems fixed in this or earlier versions 5