Compaq ProLiant Cluster HA/F500 Administrator Guide

Setting Up the ProLiant Cluster HA/F500 with Hubs
2-8 ProLiant Cluster HA/F500 for MA8000 Administrator Guide
COMPAQ CONFIDENTIAL
Writer: Woody Jernigan File Name: c-ch2
Codename: Chargers Part Number: 355220-006 Last Saved On: 7/26/02 2:48 PM
Installing the StorageWorks Command Console Client
Install the StorageWorks Command Console (SWCC) Client software on the host
designated as the maintenance terminal.
To install the SWCC Client:
1. Insert the storage subsystem CD-ROM from the HSG80 NT Intel platform kit in
the CD-ROM drive.
2. Select Solution Software for ACS.
3. Click Skip Driver Upgrade.
4. Select StorageWorks Command Console (SWCC).
5. Select CLI, Command Window, HSG80 or Newer.
6. Follow the instructions on the screen.
Configuring the Storage Subsystem for Fibre Channel
The storage subsystem is preconfigured with specific parameters. These parameters
may need to be changed depending on which cluster configuration is chosen. This
section reviews the required steps to make these changes.
Setting Controller to No Failover
To set the storage controller to no failover:
1. Click Start on the taskbar.
2. Select Programs, Command Console, CLI Window to display the Connection
Selection dialog box.
3. Select Serial and click OK to display the Connect Serial dialog box.
4. Select the COM port (the port to which the storage controller is connected).
5. Select a baud rate of 9600.