Compaq ProLiant Cluster HA/F500 Administrator Guide

Setting Up the ProLiant Cluster HA/F500 with Hubs
2-16 ProLiant Cluster HA/F500 for MA8000 Administrator Guide
COMPAQ CONFIDENTIAL
Writer: Woody Jernigan File Name: c-ch2
Codename: Chargers Part Number: 355220-006 Last Saved On: 7/26/02 2:48 PM
Configuring a Storageset
To configure a storageset:
NOTE: If errors are encountered while creating multiple storagesets, refer to the installation
troubleshooting tips in Chapter 6.
1. Select Storage in the Storage window menu line.
2. Select Add Virtual Disk to begin step 1 of the Add Virtual Disk Wizard.
3. Select one of the available RAID level settings.
4. Click Next for step 2 of the Add Virtual Disk Wizard.
5. Select the devices you want to include in the virtual disk by clicking on the disks
listed in the Available Storage window.
6. Click Next for step 3 of the Add Virtual Disk Wizard.
7. Use the displayed value for the virtual disk.
IMPORTANT: All logical partitions based in a RAID set must be in the same cluster
group.
8. Click Next for step 4 of the Add Virtual Disk Wizard.
9. Enter the virtual disk name.
10. Verify that the Save controller configuration to virtual disk check box is
selected.
11. Click Next for step 5 of the Add Virtual Disk Wizard. Step 5 will display a
summary of your selections.
NOTE: If you are not satisfied with your selections, return to the applicable Wizard step
using the Back button. When you are satisfied with your choices, click Finish.
12. Click Finish to create the virtual disk.
The Storage window displays the virtual disk you created. The hourglass on the
disk icon indicates that the storageset is being initialized. The drives you used to
create the RAID set are highlighted in the Devices window.
13. Repeat steps 1 through 12 to create other virtual disks.