FW 07.00.00/HAFM SW 08.06.00 HP StorageWorks HA-Fabric Manager User Guide (AA-RS2CF-TE, March 2005)

HA-Fabric Manager user guide 217
Log is currently in use. Access to the log is
denied because the log
was opened by another
instance of the Element
Manager.
Retry the operation later. If the
condition persists, contact the next
level of support.
Loopback plug(s) must be
installed on ports being
diagnosed. Press Next to
continue.
External loopback
diagnostics require an
optical loopback plug to
be installed.
Ensure that an optical loopback
plug is installed in port optical
transceiver before running external
wrap diagnostic testing.
Maximum number of
versions already
installed.
The number of firmware
versions that can be
defined to the HAFM
application’s firmware
library (eight) was
reached.
Delete an existing firmware version
before adding a new version.
No file was selected. Action requires the
selection of a file.
Select a file.
No firmware version file
was selected.
A file was not selected in
the Firmware Library
dialog box before an
action, such as modify or
send was performed.
Click on a firmware version in the
dialog box to select it, then
perform the action again.
No firmware versions to
delete.
There are no firmware
versions in the firmware
library to delete,
therefore the operation
cannot be performed.
Informational message only—no
action is required.
Nonredundant director
must be offline to install
firmware.
For directors, if the
director has only one CTP
card, the director must be
set offline to install a
firmware version.
For switches, since the
switch has only a single
CTP card, it must be
offline to initiate a
firmware installation.
Note that the CTP card is
an internal component
and not a FRU.
Set the director or switch offline
and install the firmware.
Table 24 Element Manager Messages (continued)
Message Description Action