HP HSR6602 Router Series FAQ

2
The router uses the LSWM1AC300 and the LSWM1DC3000 power supplies. The following table describes
their specifications:
Item
LSWM1AC300
LSWM1DC3000
Rated voltage range
100 VAC to 240 VAC @ 50 Hz or 60
Hz
–48 VDC to –60 VDC
Maximum voltage range
90 VAC to 264 VAC @ 50 Hz or 60
Hz
–40.5 VDC to –72 VDC
Maximum input current 4 A @100 VAC 10 A
Maximum output power 300 W 300 W
Q. Can I connect two AC power supplies to different power sources?
A. Yes.
Q. Are the power supplies of the router hot swappable?
A. Yes.
Q. Is the MPU of the router hot swappable?
A. No. The router uses a built-in MPU, which is not hot swappable.
Q. Does the router (including the software of the router) need any license registration?
A. No.
Q. What FIP modules are supported on the router?
A. The router supports the following FIP modules:
•
FIP-10—Has four interface module slots and supports MIMs.
•
FIP-20—Has two interface module slots and supports MIMs/HIMs.
The FIP-110 and FIP-210 are not supported.
Q. Does the router support SAP/OAP modules?
A. No.
Q. How are the slots and interfaces numbered on the router?
A. The interfaces of the router are numbered in the form of interface-type X/Y/Z, as follows:
•
Interface-type—Type of the interface, such as GE port or serial port.
•
X—Number of the slot where the MPU or the FIP-10/FIP-20 resides.
 The MPU on the router is fixed and its slot number is 0.
 The slot number for the FIP module is 1. Different interface modules on the same FIP module have the
same slot number 1.
•
Y—Number of the sub-slot where the HIM/MIM resides on the FIP module.