R3102-R3103-HP 6600/HSR6600 Routers High Availability Configuration Guide

# Set the errored frame detection interval to 20 seconds and set the errored frame event

triggering threshold to 10.

[RouterA] oam errored-frame period 20

[RouterA] oam errored-frame threshold 10

2. Configure Router B:

# Configure GigabitEthernet 3/0/1 to operate in active Ethernet OAM mode (the default) and

enable Ethernet OAM for it.

<RouterB> system-view

[RouterB] interface gigabitethernet 3/0/1

[RouterA-GigabitEthernet3/0/1] oam mode active

[RouterB-GigabitEthernet3/0/1] oam enable

[RouterB-GigabitEthernet3/0/1] quit

3. Verify the configuration:

Use the display oam configuration command to display the Ethernet OAM configuration. For

example:

# Display the Ethernet OAM configuration on Router A.

[RouterA] display oam configuration

Configuration of the link event window/threshold :

--------------------------------------------------------------------------

Errored-symbol Event period(in seconds) : 1

Errored-symbol Event threshold : 1

Errored-frame Event period(in seconds) : 20

Errored-frame Event threshold : 10

Errored-frame-period Event period(in ms) : 1000

Errored-frame-period Event threshold : 1

Errored-frame-seconds Event period(in seconds) : 60

Errored-frame-seconds Event threshold : 1

Configuration of the timer :

--------------------------------------------------------------------------

Hello timer(in ms) : 1000

Keepalive timer(in ms) : 5000

The output shows that the detection period of errored frame events is 20 seconds, the detection

threshold is 10 seconds, and all the other parameters use the default values.

You can use the display oam critical-event command to display the statistics of Ethernet OAM

critical link events. For example:

# Display the statistics of Ethernet OAM critical link events on all the ports of Router A.

[RouterA] display oam critical-event

Port : GigabitEthernet3/0/1

Link Status : Up

Event statistic :

-------------------------------------------------------------------------

Link Fault :0 Dying Gasp : 0 Critical Event : 0

The output shows that no critical link event occurred on the link between Router A and Router B.

You can use the display oam link-event command to display the statistics of Ethernet OAM link

error events. For example: