R3102-R3103-HP 6600/HSR6600 Routers High Availability Configuration Guide

# Create RPR logical interface RPR 1 on Station A, and configure the protection mode as

wrapping on the interface.

<StationA> system-view

[StationA] interface rpr 1

[StationA-RPR1] rpr protect-mode wrap

Configure Station B through Station E in the same way Station A is configured. (Details not

shown.)

2. Configure static ringlet selection:

# On RPR logical interface RPR 1 of Station A, configure transmitting frames destined for Station

B through Ringlet 1.

[StationA-RPR1] rpr static-rs 000f-e257-0002 ringlet1

[StationA-RPR1] quit

3. Verify the configuration:

# Display ring topology information on Station A.

[StationA] display rpr topology ring

Ring-level topology information on interface: RPR1

Stations on ringlet0: 4

Stations on ringlet1: 4

Total stations on ring: 5

Jumbo preference: regular

Ring topology type: closed ring

# Display the static ring selection table information on Station A.

[StationA] display rpr rs-table static

Static ringlet selection table on interface: RPR1

MAC-Address Ringlet-ID Status

-----------------------------------

000f-e257-0002 Ringlet1 Valid

--- Total entrie(s): 1 ---

# Display the information about the overall ring selection table on Station A.

[StationA] display rpr rs-table overall

Overall ringlet selection table on interface: RPR1

MAC-Address Ringlet-ID TTL Type IP-Address Station-Name

-------------------------------------------------------------------------------

000f-e257-0002 Ringlet1 4 static 0.0.0.0

000f-e257-0003 Ringlet0 2 dynamic 0.0.0.0

000f-e257-0004 Ringlet1 2 dynamic 0.0.0.0

000f-e257-0005 Ringlet1 1 dynamic 0.0.0.0

--- Total entrie(s): 4 ---