R3102-R3103-HP 6600/HSR6600 Routers High Availability Configuration Guide

87
To specify an edge node:
Step
Command
1. Enter system view.
system-view
2. Enter RRPP domain view.
rrpp domain domain-id
3. Specify the current device as a transit
node of the primary ring, and specify
the primary port and the secondary
port.
ring ring-id node-mode transit [ primary-port interface-type
interface-number ] [ secondary-port interface-type
interface-number ] level level-value
4. Specify the current device as the edge
node of a subring, and specify the edge
port.
ring ring-id node-mode edge [ edge-port interface-type
interface-number ]
Specifying an assistant-edge node
When configuring an assistant-edge node, you must first configure the primary ring before
configuring the subrings.
Perform this configuration on a device to be configured as an assistant-edge node.
To specify an assistant-edge node:
Step
Command
1. Enter system view.
system-view
2. Enter RRPP domain view.
rrpp domain domain-id
3. Specify the current device as a transit
node of the primary ring, and specify the
primary port and the secondary port.
ring ring-id node-mode transit [ primary-port interface-type
interface-number ] [ secondary-port interface-type
interface-number ] level level-value
4. Specify the current device as the
assistant-edge node of the subring, and
specify an edge port.
ring ring-id node-mode assistant-edge [ edge-port
interface-type interface-number ]
Activating an RRPP domain
To activate an RRPP domain on the current device, enable the RRPP protocol and RRPP rings for the
RRPP domain on the current device.
Perform this operation on all nodes in the RRPP domain.
To prevent Hello packets of subrings from being looped on the primary ring, enable the primary ring
on its master node before enabling the subrings on their separate master nodes. On an edge node or
assistant-edge node, enable/disable the primary ring and subrings separately:
 Enable the primary ring of an RRPP domain before enabling the subrings of the RRPP domain.
 Disable the primary ring of an RRPP domain after disabling all subrings of the RRPP domain.
To activate an RRPP domain:
Step
Command
Remarks
1. Enter system view.
system-view
N/A