R3102-R3103-HP 6600/HSR6600 Routers Interface Command Reference

217
Views
CPOS interface view
Default command level
2: System level
Parameters
e1-number: Number of an E1 channel on the CPOS interface, in the range of 1 to 63.
set-number: Channel set number, in the range of 0 to 30.
timeslot-list range: Specifies a list of timeslots assigned to the channel set. A timeslot number is in the
range of 1 to 31. While specifying timeslots, you can specify a single timeslot in the form of a number,
or timeslots in a range in the form of number1-number2, or multiple timeslots in the form of number1,
number2-number3.
Usage guidelines
When the E1 channel is channelized, its timeslot 0 is used for synchronization and the other 31 timeslots
can be bundled to form one or multiple serial interfaces. These serial interfaces are numbered in the form
of interface number/channel number:channel set number, where the interface number is separated from
the channel number by a forward slash.
IMPORTANT:
Make sure the local end has the same timeslot bundling settings as the remote end for successful
communication.
Examples
# Bundle timeslots on E1 channel 63.
<Sysname> system-view
[Sysname] controller cpos 2/0/0
[Sysname-Cpos2/0/0] e1 63 channel-set 1 timeslot-list 1-31
# Enter the view of the serial interface formed by the timeslot bundle.
[Sysname-Cpos2/0/0] quit
[Sysname] interface serial 2/0/0/63:1
[Sysname-Serial2/0/0/63:1]
Related commands
e1 unframed
e1 set clock
Use e1 set clock to set the clock mode of the E1 channel.
Use undo e1 set clock to restore the default.
Syntax
e1 e1-number set clock { master | slave }
undo e1 e1-number set clock
Default
The clock mode of the E1 channel is slave.