R3102-R3103-HP 6600/HSR6600 Routers Interface Command Reference

232
Usage guidelines
Loopback is intended for test use. Disable it otherwise.
Examples
# Enable external loopback testing on interface CPOS 2/0/0.
<Sysname> system-view
[Sysname] controller cpos 2/0/0
[Sysname-Cpos2/0/0] loopback remote
multiplex mode
Use multiplex mode to set AUG multiplexing mode.
Use undo multiplex mode to restore the default.
Syntax
multiplex mode { au-3 | au-4 }
undo multiplex mode
Default
The AUG multiplexing mode is au-4.
Views
CPOS interface view
Default command level
2: System level
Parameters
au-3: Gets AUG through AU-3.
au-4: Gets AUG through AU-4.
Usage guidelines
SDH provides two payload mapping/multiplexing solutions: ANSI and ETSI.
• ANSI uses the AU-3 multiplexing scheme, where the lower-order payload is aggregated into the
VC-3 higher-order path. VC-3 plus an AU pointer forms AU-3. Three such AU-3s can be
synchronized and multiplexed to form one AUG.
• ETSI uses the AU-4 multiplexing scheme, where the lower-order payload is aggregated into the
VC-4 higher-order path. VC-4 plus an AU pointer forms an AU-4. This AU-4 can be synchronized
and multiplexed to form one AUG.
When the CPOS interface is operating in SDH mode, you can choose to multiplex AUG to AU-4 or AU-3
by using the multiplex mode command. When the CPOS interface is operating in SONET mode, AUG
can be multiplexed only to AU-3 and the multiplex mode command is invalid.
Examples
# In SDH mode, multiplex AUG to AU-3.
<Sysname> system-view
[Sysname] controller cpos 2/0/0
[Sysname-Cpos2/0/0] frame-format sdh
[Sysname-Cpos2/0/0] multiplex mode au-3