R3102-R3103-HP 6600/HSR6600 Routers Interface Command Reference

255
Examples
# Set j0 to aa on interface E-CPOS 2/0/0 in SDH mode.
<Sysname> system-view
[Sysname] controller e-cpos 2/0/0
[Sysname-E-Cpos2/0/0] flag j0 sdh aa
frame-format
Use frame-format to configure the framing format of the current E-CPOS interface.
Use undo frame-format to restore the default.
Syntax
frame-format { sdh | sonet }
undo frame-format
Default
The framing format of an E-CPOS interface is SDH.
Views
E-CPOS interface view
Default command level
2: System level
Parameters
sdh: Sets the framing format to synchronous digital hierarchy (SDH).
sonet: Sets the framing format to synchronous optical network (SONET).
Examples
# Set the framing format of interface E-CPOS 2/0/0 to SONET.
<Sysname> system-view
[Sysname] controller e-cpos 2/0/0
[Sysname-E-Cpos2/0/0] frame-format sonet
link-delay
Use link-delay to set the physical state change suppression interval on an E-CPOS interface. In case of an
up or down event, the E-CPOS interface comes up or goes down after the physical state change
suppression interval.
Use undo link-delay to restore the default.
Syntax
link-delay seconds
undo link-delay
Default
Physical state change suppression is disabled on an E-CPOS interface.