R3102-R3103-HP 6600/HSR6600 Routers Interface Command Reference

25
After you change the link mode of an Ethernet interface, all settings are restored to their default values in
the new link mode.
Examples
# Configure GigabitEthernet 4/0/1 to operate in bridge mode.
<Sysname> system-view
[Sysname] interface gigabitethernet 4/0/1
[Sysname-GigabitEthernet4/0/1] display this
#
interface GigabitEthernet4/0/1
port link-mode route
#
Return
The output shows that GigabitEthernet 4/0/1 operates in route mode.
[Sysname-GigabitEthernet4/0/1] port link-mode bridge
[Sysname-GigabitEthernet4/0/1] display this
#
interface GigabitEthernet4/0/1
port link-mode bridge
#
Return
The output shows that GigabitEthernet 4/0/1 is now operating in bridge mode.
NOTE:
The display this command displays the configuration that takes effect in the current view.
Related commands
port link-mode interface-list
port link-mode interface-list
Use port link-mode interface-list to change the link mode of Ethernet interfaces.
Syntax
port link-mode { bridge | route } interface-list
Views
System view
Default command level
2: System level
Parameters
bridge: Specifies the bridge (Layer 2) mode.
route: Specifies the route (Layer 3) mode.
interface-list: Specifies an Ethernet interface list, in the format of interface-type interface-number [ to
interface-type interface-number ] &<1-10>, where &<1-10> indicates that you can specify up to 10
interfaces or interface ranges.