R3102-R3103-HP 6600/HSR6600 Routers Interface Configuration Guide

16
Ste
p
Command Remarks
2. Set the traffic polling interval
of the storm control module.
storm-constrain interval seconds
Optional.
The default setting is 10 seconds.
3. Enter Ethernet interface view.
interface interface-type
interface-number
N/A
4. Enable storm control, and set
the lower and upper
thresholds for broadcast,
multicast, or unknown unicast
traffic.
storm-constrain { broadcast |
multicast | unicast } { pps | kbps |
ratio } max-pps-values
min-pps-values
By default, storm control is
disabled.
5. Set the control action to take
when monitored traffic
exceeds the upper threshold.
storm-constrain control { block |
shutdown }
Optional.
No action is taken on an Ethernet
interface when a type of traffic
exceeds the upper storm control
threshold.
6. Enable the interface to send
storm control threshold event
traps.
storm-constrain enable trap
Optional.
By default, the interface sends
traps when monitored traffic
exceeds the upper threshold or
drops below the lower threshold
from the upper threshold.
7. Enable the interface to log
storm control threshold events.
storm-constrain enable log
Optional.
By default, the interface outputs log
messages when monitored traffic
exceeds the upper threshold or
falls below the lower threshold
from the upper threshold.
Configuring a Layer 3 Ethernet interface or
subinterface
Layer 3 Ethernet interface configuration task list
Perform the following configuration on Ethernet interfaces operating in route mode:
Task Remarks
Setting the MTU for an Ethernet interface or
subinterface
Optional.
Applicable to Layer 3 Ethernet interfaces and Ethernet
subinterfaces.
Configuring an Ethernet interface to operate in
promiscuous mode
Optional.
Applicable to Layer 3 Ethernet interfaces.