R3102-R3103-HP 6600/HSR6600 Routers Interface Configuration Guide

45
Ste
p
Command Remarks
15. Set the FDL format for a T1
channel.
t1 line-number set fdl { ansi | att |
both | none }
Optional.
By default, FDL is disabled.
This operation applies only to T1
channels that are formed on CT3
interfaces, operate in channelized
mode, and use ESF as the T1
framing format.
16. Set the intended bandwidth
for the CT3 interface.
bandwidth bandwidth-value Optional.
17. Restore the default settings for
the CT3 interface.
default Optional.
18. Enter synchronous serial
interface view of an interface
formed by a CT3 interfaces.
• interface serial
number/line-number:0
• interface serial
number/line-number:set-numb
er
N/A
19. Set the CRC mode.
crc { 16 | 32 | none }
Optional.
By default, 16-bit CRC is adopted..
Note:
FEAC = Far end and control signal; MDL = Maintenance data link; PPR = Periodical performance report
Displaying and maintaining CT3 interfaces
Task Command Remarks
Display the state information of
CT3 interface.
display controller t3
[ interface-number ] [ | { begin |
exclude | include }
regular-expression ]
Available in any view.
Display the configuration and state
of a serial interface formed on a
CT3 interface.
display interface serial
interface-number [ | { begin | exclude
| include } regular-expression ]
Available in any view.
Clear the controller counter of a
CT3 interface.
reset counters controller t3
interface-number
Available in user view.
Display the state of a T1 line. t1 line-number show
Available in CT3 interface
view.
Shut down a CT3 interface. shutdown
Available in CT3 interface
view.
CAUTION:
Make sure you are fully aware
of the impact of the shutdown
action on your network.
Bring up a CT3 interface. undo shutdown
Available in CT3 interface
view.