R3102-R3103-HP 6600/HSR6600 Routers IP Multicast Command Reference

306
[Sysname] interface gigabitethernet2/1/1
[Sysname-GigabitEthernet2/1/1] mld max-response-time 8
Related commands
• display mld interface
• max-response-time
• mld timer other-querier-present
mld proxying enable
Use mld proxying enable to enable MLD proxying on an interface.
Use undo mld proxying enable to disable MLD proxying on the interface.
Syntax
mld proxying enable
undo mld proxying enable
Default
MLD proxying is disabled.
Views
Interface view
Default command level
2: System level
Usage guidelines
This command takes effect only after IPv6 multicast routing is enabled.
If MLD proxying is enabled on a loopback interface, the proxy device maintains only the MLD routing
table without adding the MLD routes to the multicast routing table and forwarding table.
Examples
# Enable IPv6 multicast routing and enable MLD proxying on GigabitEthernet 2/1/1.
<Sysname> system-view
[Sysname] multicast ipv6 routing-enable
[Sysname] interface gigabitethernet 2/1/1
[Sysname-GigabitEthernet2/1/1] mld proxying enable
Related commands
multicast ipv6 routing-enable
mld proxying forwarding
Use mld proxying forwarding to enable a non-querier downstream interface to forward multicast traffic.
Use undo mld proxying forwarding to disable the forwarding capability of a non-querier downstream
interface.
Syntax
mld proxying forwarding