R3102-R3103-HP 6600/HSR6600 Routers IP Multicast Configuration Guide

199
Controlling route advertisement and reception
Configuration prerequisites
You must configure basic MBGP functions before you configure this task.
Configuring MBGP route redistribution
MBGP can advertise routing information in the local AS to neighboring ASs. It redistributes such routing
information from IGP into its routing table rather than learns the information by itself.
Follow these guidelines when you configure MBGP route redistribution:
• The Origin attribute of routes redistributed into the MBGP routing table with the import-route
command is Incomplete.
• The Origin attribute of routes injected into the MBGP routing table with the network command is
IGP.
• The networks to be injected must exist in the local IP routing table, and using a routing policy makes
route control more flexible.
To configure MBGP route redistribution:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv4 MBGP address
family view.
ipv4-family multicast N/A
4. Configure route redistribution
from another routing protocol.
• Enable route redistribution from
another routing protocol:
import-route protocol
[ { process-id | all-processes }
[ allow-direct | med med-value
| route-policy
route-policy-name ] * ]
• Inject a network into the MBGP
routing table:
network ip-address [ mask |
mask-length ] [ short-cut |
route-policy route-policy-name ]
At least one of these methods is
required.
No route redistribution is
configured by default.
The allow-direct keyword is
available only when the specified
routing protocol is OSPF.
Configuring default route redistribution into MBGP
Using only the import-route command cannot redistribute any default route into MBGP. This task enables
default route redistribution into the MBGP routing table.
To configure MBGP to redistribute a default route from another protocol:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A