R3102-R3103-HP 6600/HSR6600 Routers Layer 2 - LAN Switching Command Reference

37
service
Use service to specify a card to process traffic for the interface.
Use undo service to restore the default setting.
Syntax
service slot slot-number
undo service slot
Default
Traffic on a Layer 3 aggregate interface whose member ports are located on the same card is processed
and forwarded by the card that houses the member ports, and traffic on a Layer 3 aggregate interface
whose member ports are located on different cards is processed and forwarded by the card that houses
the first selected member port.
Views
Layer 3 aggregate interface view
Default command level
2: System level
Parameters
slot slot-number: Specifies the card by its slot number to process and forward traffic for the interface.
Usage guidelines
If you do not specify a card to process and forward traffic for a Layer 3 aggregate interface whose
member ports are located on different cards, the traffic might be processed and forwarded by different
cards from time to time due to changes in the Selected ports.
If the card specified by this command is removed, the traffic will be interrupted. After the card is
re-installed, traffic forwarding is restored.
On distributed routers of the 6600 and HSR6600 series, you are not allowed to use this command to
specify the MPU to forward traffic for Layer 3 aggregate interfaces, because all traffic must be forwarded
on base cards.
The following matrix shows the command and router compatibility:
Command 6602 HSR6602 6604/6608/6616
service
No Yes Yes
Examples
# Specify the card in slot 2 to process and forward traffic on Layer 3 aggregate interface
Route-Aggregation 1.
<Sysname> system-view
[Sysname] interface route-aggregation 1
[Sysname-Route-Aggregation1] service slot 2
shutdown
Use shutdown to shut down the aggregate interface or subinterface.