R3102-R3103-HP 6600/HSR6600 Routers Layer 2 - LAN Switching Configuration Guide

139
Figure 47 Network diagram
Configuration procedure
1. Configure Router A:
# Enable GVRP globally.
<RouterA> system-view
[RouterA] gvrp
# Configure port GigabitEthernet 3/0/1 as a trunk port, and assign it to all VLANs.
[RouterA] interface GigabitEthernet 3/0/1
[RouterA-GigabitEthernet3/0/1] port link-type trunk
[RouterA-GigabitEthernet3/0/1] port trunk permit vlan all
# Enable GVRP on GigabitEthernet 3/0/1 and set the GVRP registration mode to fixed on the
port.
[RouterA-GigabitEthernet3/0/1] gvrp
[RouterA-GigabitEthernet3/0/1] gvrp registration fixed
[RouterA-GigabitEthernet3/0/1] quit
# Create VLAN 2 (a static VLAN).
[RouterA] vlan 2
[RouterA-vlan2] quit
2. Configure Router B:
# Enable GVRP globally.
<RouterB> system-view
[RouterB] gvrp
# Configure port GigabitEthernet 3/0/1 as a trunk port, and assign it to all VLANs.
[RouterB] interface GigabitEthernet 3/0/1
[RouterB-GigabitEthernet3/0/1] port link-type trunk
[RouterB-GigabitEthernet3/0/1] port trunk permit vlan all
# Enable GVRP on GigabitEthernet 3/0/1, and set the GVRP registration mode to fixed on the
port.
[RouterB-GigabitEthernet3/0/1] gvrp
[RouterB-GigabitEthernet3/0/1] gvrp registration fixed
[RouterB-GigabitEthernet3/0/1] quit
# Create VLAN 3 (a static VLAN).
[RouterB] vlan 3
[RouterB-vlan3] quit
3. Verify the configuration:
Use the display gvrp local-vlan command to display the local VLAN information that GVRP
maintains on ports. For example:
# Display the local VLAN information maintained by GVRP on port GigabitEthernet 3/0/1 of
Router A.
[RouterA] display gvrp local-vlan interface GigabitEthernet 3/0/1
Following VLANs exist in GVRP local database: