R3102-R3103-HP 6600/HSR6600 Routers Layer 2 - LAN Switching Configuration Guide

25
Ste
p
Command Remarks
3. Set the expected bandwidth
for the aggregate interface.
bandwidth bandwidth-value N/A
Shutting down an aggregate interface
Shutting down or bringing up an aggregate interface affects the aggregation state and link state of
aggregated member ports in the following ways:
• When an aggregate interface is shut down, all Selected member ports become unselected and
their link state becomes down. Shutting down a Layer 3 aggregate subinterface does not affect any
aggregation group, because Layer 3 aggregate subinterfaces are not associated with any
aggregation groups.
• When an aggregate interface is brought up, the aggregation state of member ports is recalculated
and their link state becomes up.
To shut down an aggregate interface:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter aggregate interface
view.
• Enter Layer 2 aggregate
interface view:
interface bridge-aggregation
interface-number
• Enter Layer 3 aggregate
interface view:
interface route-aggregation
interface-number
Use either command.
3. Shut down the aggregate
interface or subinterface.
shutdown
By default, aggregate interfaces or
subinterfaces are up.
Restoring the default settings for an aggregate interface
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter aggregate interface
view.
• Enter Layer 2 aggregate interface view:
interface bridge-aggregation
interface-number
• Enter Layer 3 aggregate interface view:
interface route-aggregation
interface-number
Use either command.
3. Restore the default settings for
the aggregate interface or
subinterface.
default N/A