R3102-R3103-HP 6600/HSR6600 Routers Layer 2 - WAN Command Reference Guide

12
Table 7 Command output
Field Descri
p
tion
VPI Virtual path identifier of the specified ATM PVC.
VCI Virtual channel identifier of the specified ATM PVC.
INDEX Internal index of the PVC.
AAL5 Encaps AAL5 encapsulation type of the PVC.
Protocol Upper layer protocol running on the PVC.
Service-type Service type.
Transmit-Priority Transmit priority.
OAM interval Interval at which OAM F5 loopback cells are sent.
OAM retry interval Interval at which the system retransmits OAM F5 loopback cells.
OAM retry count Number of OAM cells transmitted before a PVC is declared up or down.
OAM ais-rdi count
Number of OAM AIS/RDI cells for the device to receive before reporting that the
PVC is down. Number of seconds for the device to wait before reporting that the
PVC is up after the PVC has stopped receiving OAM AIS/RDI cells.
input pkts: Count of received packets.
input bytes: Count of received bytes.
input pkt errors: Count of received error packets.
output pkts Count of transmitted packets.
output bytes Count of transmitted bytes.
output pkt errors Count of transmitted error packets.
Interface State Link layer protocol status of the interface.
PVC State PVC status.
Output queue Information about each output queue on the PVC.
OAM cells received Count of received OAM cells.
F5 InEndloop Count of received F5 loopback cells.
F5 InAIS
Count of received AIS cells.
If the AIS alarm state is not supported, this command displays only the count of
AIS cells, not the AIS alarm state, which is the OAM AIS State field.
F5 InRDI
Count of received RDI cells.
If the RDI alarm state is not supported, this command displays only the count of
RDI cells, not the RDI alarm state, which is the OAM RDI State field.
OAM cells sent Count of transmitted OAM cells.
F5 OutEndloop Count of transmitted F5 loopback cells.
OAM AIS State
AID alarm state.
If the AIS alarm state is supported, this command displays only the AIS alarm
state, not the count of received AIS cells, which is the F5 InAIS field.
OAM RDI State
If the RDI alarm state is supported, this command displays only the RDI alarm
state, not the count of received RDI cells, which is the F5 InRDI field.