R3102-R3103-HP 6600/HSR6600 Routers Layer 2 - WAN Command Reference Guide

40
Views
Interface view
Default command level
2: System level
Parameters
chap: Uses CHAP authentication.
ms-chap: Uses MS-CHAP authentication.
ms-chap-v2: Uses MS-CHAP-V2 authentication.
pap: Uses PAP authentication.
call-in: Authenticates the call-in users only.
domain isp-name: Specifies the domain name for authentication, a case-insensitive string of 1 to 24
characters.
Usage guidelines
If you run the ppp authentication-mode command with the domain keyword specified, you must
configure an address pool in the corresponding domain. You can use the display domain command to
display the domain configuration.
If you configure the ppp authentication-mode command without specifying the domain name, the system
checks the username for domain information. If the username contains a domain name, the domain will
be used for authentication If the domain does not exist, the user's access request will be denied. If the
username does not contain a domain name, the default domain is used. You can use the domain default
command to configure the default domain. If no default domain is configured, the default domain system
is used by default.
PPP authentication falls into the following categories:
• PAP—Two-way handshake authentication. The password used is in plain text.
• CHAP—Three-way handshake authentication. The password is in cipher text.
• MS-CHAP—Three-way handshake authentication. The password is in cipher text.
• MS-CHAP-V2—Three-way handshake authentication. The password is in cipher text.
You can configure several authentication modes simultaneously. In any PPP authentication mode, AAA
determines whether a user can pass the authentication through a local authentication database or an
AAA server.
Examples
# Configure interface Serial 2/0/1 to authenticate the peer device by using PAP.
<Sysname> system-view
[Sysname] interface serial 2/0/1
[Sysname-Serial2/0/1] ppp authentication-mode pap domain system
# Configure interface Serial 2/0/1 to authenticate the peer device by using PAP, CHAP, and MS-CHAP.
<Sysname> system-view
[Sysname] interface serial 2/0/1
[Sysname-Serial2/0/1] ppp authentication-mode pap chap ms-chap domain system
Related commands
• ppp chap user