R3102-R3103-HP 6600/HSR6600 Routers Layer 2 - WAN Command Reference Guide

50
Parameters
number: Maximum number of links that can be used for transmitting multicast or broadcast packets, in
the range of 0 to 128. A value of 0 indicates that the transmission of multicast or broadcast packets is not
supported.
Usage guidelines
For a VT containing multiple links, the system performance may decrease if all the links of the VT are
engaged in multicast or broadcast packet transmission. You can use the broadcast-limit link command
to limit the number of links that are capable of multicast or broadcast packet transmission.
Examples
# Set the maximum number of links that are capable of multicast or broadcast packets transmission to
100 for VT 1.
<Sysname> system-view
[Sysname] interface virtual-template 1
[Sysname-Virtual-Template1] broadcast-limit link 100
default
Use default to restore the default setting for the VT or MP-group interface.
Syntax
default
Views
VT interface view, MP-group interface view
Default command level
2: System level
Usage guidelines
CAUTION:
The default command might interrupt ongoing network services. Make sure you are fully aware of the
impacts of this command when you execute it on a live network.
This command might fail to restore the default settings for some commands for reasons such as command
dependencies and system restrictions. Use the display this command in interface view to identify these
commands, and then use their undo forms or follow the command reference to individually restore their
default settings. If your restoration attempt still fails, follow the error message instructions to resolve the
problem.
Examples
# Restore the default setting of interface VT 10.
<Sysname> system-view
[Sysname] interface virtual-template 10
[Sysname-Virtual-Template10] default
This command will restore the default settings. Continue? [Y/N]:y
# Restore the default setting of interface MP-group 3.
<Sysname> system-view