R3102-R3103-HP 6600/HSR6600 Routers Layer 2 - WAN Command Reference Guide

67
Views
Interface view
Default command level
2: System level
Usage guidelines
This command applies to the incoming direction only. To enable the local end to transmit packets with
short sequence numbers, configure the remote end to receive packets with short sequence numbers.
The sequence number format (long or short) of an MP bundle depends on the configuration of the first
channel joining the MP bundle.
To negotiate the use of short sequence numbers on a dialer MP bundle, configure the command on the
ISDN D channel; to do that on a common MP bundle, use the command on all its channels. The
command will cause PPP re-negotiation.
Examples
# Configure the short sequence number header format of MP in the incoming direction of interface Serial
2/0/1.
<Sysname> system-view
[Sysname] interface serial 2/0/1
[Sysname-Serial2/0/1] ppp mp mp-group 0
[Sysname-Serial2/0/1] ppp mp short-sequence
ppp mp user
Use ppp mp user to specify to add PPP links with specific usernames to the corresponding MP bundles
according to usernames.
Use undo ppp mp user to remove a username-based MP bundle.
Syntax
ppp mp user username bind virtual-template number
undo ppp mp user username
Views
System view
Default command level
2: System level
Parameters
username: Username, a string of 1 to 80 characters.
virtual-template number: Specifies a virtual-template number, in the range of 0 to 1023.
Usage guidelines
In establishing a PPP connection, if PPP authentication succeeds and a virtual-template is specified, the
PPP link established will be added to the corresponding MP bundle according to the configuration of the
virtual-template, and a new virtual interface will be formed for data transmission.
You can configure the following parameters for a virtual-template:
• Local IP address and the peer IP address (or IP address pool)