R3102-R3103-HP 6600/HSR6600 Routers Layer 2 - WAN Configuration Guide

15
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a Layer 2
VE interface and
enter the interface
view.
interface ve-bridge
interface-number
If a specified Layer 2 VE interface does not exist, use this
command to first create one and then enter its view.
You can create up to 1024 Layer 2 VE interfaces.
3. Set the interface
description.
description text
Optional.
By default, the description of a Layer 2 VE interface is
interface name Interface, for example,
Virtual-Ethernet2/0/0 Interface.
4. Configure the
MAC address for
the interface.
mac-address mac-address
Optional.
5. Set the intended
bandwidth of the
interface.
bandwidth
bandwidth-value
Optional.
6. Restore the
default settings of
the interface.
default Optional.
7. Shut down the
interface.
shutdown
Optional.
Up by default.
Configuring IPoA
When you configure IPoA, follow these guidelines:
• If you execute the map ip command with the broadcast keyword, which specifies pseudo broadcast,
any broadcast packets received by the port on which the PVC is created will be duplicated to the
PVC. Therefore, to propagate broadcast or multicast packets on an ATM PVC with a broadcast or
multicast protocol enabled, specify the broadcast keyword.
• Configure the map ip default broadcast command on PVCs created on P2P ATM subinterfaces.
• You can configure PVC mapping in PVC view. For more information, see MPLS Configuration
Guide.
To configure IPoA:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter ATM interface view.
interface atm { interface-number |
interface-number.subnumber }
N/A
3. Create a PVC, and enter PVC
view.
pvc { pvc-name [ vpi/vci ] |
vpi/vci }
N/A