R3102-R3103-HP 6600/HSR6600 Routers Layer 3 - IP Routing Configuration Guide

125
Solution
1. Use the display ospf peer command to verify neighbor information.
2. Use the display ospf interface command to verify OSPF interface information.
3. Use the display ospf lsdb command to verify the LSDB.
4. Use the display current-configuration configuration ospf command to verify area configuration. If
more than two areas are configured, at least one area is connected to the backbone.
5. In a stub area, all routers attached are configured with the stub command. In an NSSA area, all
routers attached are configured with the nssa command.
6. If a virtual link is configured, use the display ospf vlink command to verify the state of the virtual
link.