R3102-R3103-HP 6600/HSR6600 Routers Layer 3 - IP Routing Configuration Guide

327
• To implement area-based IPsec protection, configure the same IPsec policy on the routers in the
target area.
• To implement interface-based IPsec protection, configure the same IPsec policy on the interfaces
between two neighboring routers.
• To implement virtual link-based IPsec protection, configure the same IPsec policy on the two routers
connected over the virtual link.
If an interface and its area each have an IPsec policy configured, the interface uses its own IPsec policy.
If a virtual link and area 0 each have an IPsec policy configured, the virtual link uses its own IPsec policy.
Configuration prerequisites
Before applying an IPsec policy for OSPFv3, complete the following tasks:
• Create an IPsec proposal.
• Create an IPsec policy.
For more information about IPsec policy configuration, see Security Configuration Guide.
Configuration procedure
An IPsec policy used for OSPFv3 can only be in manual mode. For more information, see Security
Configuration Guide.
To apply an IPsec policy in an area:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPFv3 view.
ospfv3 [ process-id ] N/A
3. Enter OSPF area view.
area area-id N/A
4. Apply an IPsec policy in the
area.
enable ipsec-policy policy-name Not configured by default.
To apply an IPsec policy on an interface:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Apply an IPsec policy on the
interface.
ospfv3 ipsec-policy policy-name
[ instance instance-id ]
Not configured by default.
To apply an IPsec policy on a virtual link:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPFv3 view.
ospfv3 [ process-id ] N/A
3. Enter OSPF area view.
area area-id N/A