R3102-R3103-HP 6600/HSR6600 Routers Layer 3 - IP Routing Configuration Guide

36
Ste
p
Command Remarks
2. Configure the source IP
address of BFD echo packets.
bfd echo-source-ip ip-address
By default, no source IP address is
configured for BFD echo packets.
3. Enter interface view.
interface interface-type
interface-number
N/A
4. Enable BFD for RIP.
rip bfd enable destination
ip-address
By default, BFD for RIP is disabled.
The rip bfd enable destination
command and the rip bfd enable
command are mutually exclusive
and cannot be configured on a
device at the same time.
Enabling bidirectional control detection
This feature only works for RIP neighbors that are directly connected (one hop away from each other).
To configure BFD for RIP (bidirectional control detection):
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a RIP process and
enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
By default, RIP is disabled.
3. Specify a RIP neighbor.
peer ip-address
By default, RIP does not unicast
updates to any peer.
4. Enter interface view.
interface interface-type
interface-number
N/A
5. Enable BFD on the RIP
interface.
rip bfd enable Disabled by default.
NOTE:
Because the undo peer command does not remove the neighbor relationship at once, executing the
command cannot bring down the BFD session at once.
Displaying and maintaining RIP
Task Command Remarks
Display RIP current status and
configuration information.
display rip [ process-id |
vpn-instance vpn-instance-name ]
[ | { begin | exclude | include }
regular-expression ]
Available in any view.
Display all active routes in RIP
database.
display rip process-id database [ |
{ begin | exclude | include }
regular-expression ]
Available in any view.