R3102-R3103-HP 6600/HSR6600 Routers Layer 3 - IP Routing Configuration Guide

Figure 8 Network diagram

Configuration procedure

1. Configure IP addresses for interfaces. (Details not shown.)

2. Configure basic RIP basic functions:

# Enable RIP 100, and configure a RIPv2 on Router A.

<RouterA> system-view

[RouterA] rip 100

[RouterA-rip-100] network 10.0.0.0

[RouterA-rip-100] network 11.0.0.0

[RouterA-rip-100] version 2

[RouterA-rip-100] undo summary

[RouterA-rip-100] quit

# Enable RIP 100 and RIP 200, configure RIPv2 on Router B.

<RouterB> system-view

[RouterB] rip 100

[RouterB-rip-100] network 11.0.0.0

[RouterB-rip-100] version 2

[RouterB-rip-100] undo summary

[RouterB-rip-100] quit

[RouterB] rip 200

[RouterB-rip-200] network 12.0.0.0

[RouterB-rip-200] version 2

[RouterB-rip-200] undo summary

[RouterB-rip-200] quit

# Enable RIP 200 and configure RIPv2 on Router C.

<RouterC> system-view

[RouterC] rip 200

[RouterC-rip-200] network 12.0.0.0

[RouterC-rip-200] network 16.0.0.0

[RouterC-rip-200] version 2

[RouterC-rip-200] undo summary

[RouterC-rip-200] quit

# Display the routing table on Router C.

[RouterC] display ip routing-table

Routing Tables: Public

Destinations : 6 Routes : 6

Destination/Mask Proto Pre Cost NextHop Interface

12.3.1.0/24 Direct 0 0 12.3.1.2 GE2/1/1

12.3.1.2/32 Direct 0 0 127.0.0.1 InLoop0