R3102-R3103-HP 6600/HSR6600 Routers Layer 3 - IP Services Command Reference

267
Tunneling configuration commands
bandwidth
Use bandwidth to set the intended bandwidth for the tunnel interface.
Use undo bandwidth to remove the setting.
Syntax
bandwidth bandwidth-value
undo bandwidth
Views
Tunnel interface view
Default command level
2: System level
Parameters
bandwidth-value: Intended bandwidth for the tunnel interface, in the range of 1 to 4294967295 kbps.
Usage guidelines
You can obtain the intended bandwidth of an interface by querying the speed value of the MIB node with
third-party software.
The intended bandwidth is used for bandwidth monitoring of the network management, but does not
affect the actual bandwidth of the interface.
Examples
# Set the intended bandwidth for interface Tunnel 0 to 10000 kbps.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] bandwidth 10000
default
Use default to restore the default settings for the tunnel interface.
Syntax
default
Views
Tunnel interface view
Default command level
2: System level
Usage guidelines