R3102-R3103-HP 6600/HSR6600 Routers MPLS Command Reference Guide

156
Use undo mpls te record-route to restore the default.
Syntax
mpls te record-route [ label ]
undo mpls te record-route
Default
A tunnel does not support route recording or label recording.
Views
Tunnel interface view
Default command level
2: System level
Parameters
label: Includes the record of labels in the route record. This keyword is not supported when the signaling
protocol is CR-LDP.
Examples
# Enable route recording on MPLS TE tunnel 0.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te record-route
mpls te reoptimization (tunnel interface view)
Use mpls te reoptimization to enable reoptimization on the tunnel.
Use undo mpls te reoptimization to disable reoptimization on the tunnel.
Syntax
mpls te reoptimization [ frequency seconds ]
undo mpls te reoptimization
Default
Reoptimization is disabled.
Views
Tunnel interface view
Default command level
2: System level
Parameters
frequency seconds: Specifies reoptimization frequency in the range of 1 to 604800 seconds. The default
is 3600 seconds, or 1 hour.
Usage guidelines
The reoptimization function cannot be used together with these commands: mpls te auto-bandwidth
adjustment, mpls te route-pinning, mpls te backup, and mpls te resv-style ff.