R3102-R3103-HP 6600/HSR6600 Routers MPLS Command Reference Guide

167
Default
The opaque LSA capability of OSPF is disabled.
Views
OSPF view
Default command level
2: System level
Parameters
enable: Enables the opaque LSA capability.
Examples
# Enable the opaque LSA capability of OSPF.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] opaque-capability enable
ping lsp te
Use ping lsp te to check MPLS TE tunnel connectivity.
Syntax
ping lsp [ -a source-ip | -c count | -exp exp-value | -h ttl-value | -m wait-time | -r reply-mode | -s
packet-size | -t time-out | -v ] * te interface-type interface-number
Views
Any view
Default command level
0: Visit level
Parameters
-a source-ip: Specifies the source IP address of the Echo Request messages to be sent.
-c count: Specifies the number of Echo Request messages to be sent. The value range for the count
argument is 1 to 4294967295, and the default is 5.
-exp exp-value: Specifies the EXP value for the Echo Request messages. The value range for the exp-value
argument is 0 to 7, and the default is 0.
-h ttl-value: Specifies the TTL value for the Echo Request messages. The value range for the ttl-value
argument is 1 to 255, and the default is 255.
-m wait-time: Specifies the interval for sending Echo Request messages. The value range for the wait-time
argument is 1 to 10000 milliseconds, and the default is 200 milliseconds.
-r reply-mode: Specifies the reply mode of the receiver in response to an Echo Request message. The
reply-mode argument can be 1 or 2. 1 means "Do not respond," and 2 means "Respond using a UDP
packet." The default is 2.
-s packet-size: Specifies the payload length of the Echo Request messages. The value range for the
packet-size argument is 65 to 8100 bytes, and the default is 100 bytes.