R3102-R3103-HP 6600/HSR6600 Routers MPLS Command Reference Guide

175
Views
IS-IS view
Default command level
2: System level
Parameters
level-1: Enables Level-1 IS-IS TE.
level-1-2: Enables Level-1-2 IS-IS TE.
level-2: Enables Level-2 IS-IS TE.
NOTE:
If no level is specified, IS-IS TE applies to Level-1-2.
Usage guidelines
To enable IS-IS TE, you must use the cost-style command to configure the IS-IS cost style as wide,
compatible, or wide-compatible. For more information about the cost-style command, see Layer 3—IP
Routing Command Reference.
Examples
# Enable TE for Level-2 IS-IS process 1.
<Sysname> system-view
[Sysname] isis 1
[Sysname-isis-1] cost-style compatible
[Sysname-isis-1] traffic-eng level-2