R3102-R3103-HP 6600/HSR6600 Routers MPLS Command Reference Guide

62
[Sysname] mpls ldp remote-peer bji
[Sysname-mpls-ldp-remote-bji] prefix-label advertise
remote-ip
Use remote-ip to configure the remote peer IP address.
Use undo remote-ip to remove the configuration.
Syntax
remote-ip ip-address
undo remote-ip
Views
MPLS LDP remote peer view
Default command level
2: System level
Parameters
ip-address: Specifies the remote peer IP address.
Usage guidelines
The remote peer IP address must be the MPLS LSR ID of the remote peer. Two peers use their MPLS LSR
IDs as the transport addresses to establish a TCP connection.
Examples
# Configure the remote peer IP address as 3.3.3.3.
<Sysname> system-view
[Sysname] mpls ldp remote-peer BJI
[Sysname-mpls-ldp-remote-bji] remote-ip 3.3.3.3
Related commands
mpls ldp remote-peer
remote-ip bfd
Use remote-ip bfd to enable BFD to detect the IP connectivity to the remote LDP peer.
Use undo remote-ip bfd to disable BFD detection of the IP connectivity to the remote LDP peer.
Syntax
remote-ip bfd
undo remote-ip bfd
Default
BFD detection is disabled.
Views
MPLS LDP remote peer view